Want to Buy: 1999 Radio Bezel - CA
#1
1999 Radio Bezel - CA
Kinda funny but then again not.
I recently bought a 1999 Ranger 4X4 and for the first time tried to push in the lighter to see if it worked. It wouldnt move so I tried to pull the lighter out. Nope. I then yanked on it and BOY did it come out!
The lighter appears to have been glued in so when I yanked the bezel broke and the entire unit came through the now large hole.
I am now seeking a replacement that has:
4wd + Foglights + Cig lighter + 12v.
Two foglight switches is also fine provided it come with the additional switch
I'm in Burbank Calif
I recently bought a 1999 Ranger 4X4 and for the first time tried to push in the lighter to see if it worked. It wouldnt move so I tried to pull the lighter out. Nope. I then yanked on it and BOY did it come out!
The lighter appears to have been glued in so when I yanked the bezel broke and the entire unit came through the now large hole.
I am now seeking a replacement that has:
4wd + Foglights + Cig lighter + 12v.
Two foglight switches is also fine provided it come with the additional switch
I'm in Burbank Calif
#2
PS I have checked local junk yards none have this setup. The close ones are trashed. Broken tabs etc
No love checking e-Bay so far
No love checking e-Bay so far
Last edited by Crazy4DaRiver; 08-14-2011 at 12:00 PM.
#4
Ty Buddy. I fixed it due to absolute necessity.
I took two of those 2 dollar add-on 12V plugs from a local auto parts place then very carefully cut the outside ring off with a Dremel. That left just enough to slide what was left back in from the back of the bexel. I Then used Gorrilla Glue and let it sit for about 20 hours. For giggles I did the same to the 12V plug. Hense 2.
So far it is rock solid and I change devices constantly. I also broke down and hardwired a 12V multi port with USB. Not a single issue since But TY for asking
I took two of those 2 dollar add-on 12V plugs from a local auto parts place then very carefully cut the outside ring off with a Dremel. That left just enough to slide what was left back in from the back of the bexel. I Then used Gorrilla Glue and let it sit for about 20 hours. For giggles I did the same to the 12V plug. Hense 2.
So far it is rock solid and I change devices constantly. I also broke down and hardwired a 12V multi port with USB. Not a single issue since But TY for asking
#6
Old Guy User…
iTrader: (12)
I have three or four units for sale and you need to pick the configuration.
Thks
Here's one... https://www.ranger-forums.com/interi...ins-ma-137182/
Thread
Thread Starter
Forum
Replies
Last Post
Want to Trade: Explorer Radio Bezel for Ranger Radio Bezel - ON
platinum6316
OLD - Interior, Exterior, Electrical, & Misc.
0
11-26-2011 06:02 AM
jordanvw
Interior Semi-Tech
7
05-24-2011 08:37 AM
Redneckstone
Interior, Exterior, & Electrical
0
03-31-2010 10:18 PM